Skip to main content
A slab corner can be a tangent arc instead of a point. You give a radius for the corner, and the area, the plan, the 3D body and the IFC export follow the curve.

Before you start

You have a session from Start a building. You know how to add a floor slab.

Write the slab

This page uses its own slab: a square of 4 metres by 4 metres, with the id round-slab. Its area is 16 square metres.

Round one corner

The set-corner-radius command takes the list of the element, the id of the element, the ring ('outer' or the index of a hole), the corners and a radius in metres. The corners are indices of the points of the ring. One command is one undo step.
A radius of 1 metre takes away (1 - π/4) × r², which is 0.2146 square metres, from the corner.

Round all four corners

Give the four indices in one command.

Make the corners sharp again

A radius of null makes the corners sharp. The slab is the square again.

Read the exact area

storeyFloorAreas measures the slabs of a storey and counts each arc exactly. The walls do not count when the storey has a slab.
The area is 16 square metres with sharp corners, 15.7854 with one corner of 1 metre, and 15.1416 with all four. A square of 4 metres loses 4 × 0.2146 = 0.8584 square metres.

What is refused

The model has the radius in cornerRadii.outerRing, with one entry for each corner of profile and null for a sharp corner. cornerRadii.holes[i] does the same for hole i. The kernel refuses a radius in two cases:
  • The radius does not fit. The two corners at the ends of an edge share that edge. The command is refused with corner-radius-too-big, and the message names the corner and the largest radius that fits. On a 4 metre edge, two corners of 2 metres give a half-round end, and two corners of more than 2 metres do not fit.
  • The corner is beside an arc edge. A corner next to an edge from arcs takes no radius, and the command is refused with corner-radius-arc-edge.
A corner that you drag keeps its radius, and the radius shrinks to fit if it must.

Round a corner in the plan editor

In the reshape mode of the plan, each slab corner has a round-corner handle on its bisector.
  • Drag the handle to set a radius. The radius is limited to the largest that fits, and the plan shows it in millimetres.
  • Type a number in millimetres and press Enter for an exact value.
  • Drag the handle back onto the corner to make it sharp.
The inspector has the rows Corner radius and All corners. They take metres, and 0 clears the radius.

Next

Add a floor slab

Outline, thickness, edge profile and curved edges.

Slab API

See each option of a slab.
Last modified on November 10, 2026